OptiMate 6 Battery Optimiser (TML10S)

R2,063.19

The world’s most advanced fully automatic 12V battery charger!

OptiMate 6 saves batteries other chargers can’t, because it recognizes the difference between a discharged battery that needs charging and a dead flat sulphated battery that needs saving. Perfect for months-long maintenance of any size 12V lead-acid battery – deep cycle, automotive, marine, motorcycle …

Multi-stage desulphation: Restores neglected batteries from as low as 0.5 Volts.
Ampmatic charge control: adjusts current to suit any battery size (3 to 240Ah) OR condition for fastest and most complete charge.
Cell voltage balancing mode: correctly prepares NEW batteries for first use and optimizes battery performance.
Daily battery condition tests & interactive float charge: maintains battery fully charged, weeks or months long.

CHARGING AMPS : 5A (Ampmatic)
USE : Indoor / Outdoor (lowest temperature: -40ºC).
SAVE : Low Volt Start of 0.5V + 2-step desulphation recovery.
IDEAL FOR : STD, AGM & GEL 12V batteries from 3 – 240Ah.
INPUT : Global (100-240V 50-60Hz), high efficiency (CEC listed), fully sealed.
STYLE : Weatherproof case with wall mounts, with 180cm AC supply lead and 180cm charge lead ending in SAE connector. Weatherproof battery lead & standard battery clip set included.

SAFE: No risk of overcharging. Totally safe for vehicle electronics. Sparks suppressed. Safe for long-term battery maintenance. Automatic shut-down if short-circuited or battery disconnected. 3-year limited replacement warranty.

Ideal for 12V lead-acid batteries: 3Ah to 240Ah, AGM (MF), Standard, GEL and AGM spiral cell
Program control: ampmaticTM microprocessor
Output current (bulk charge): 0.4A – 5.0A
Automatic desulphation: multistage (high voltage, turbo and pulse mode)
Charge time limit: 72 hours (maintenance time: unlimited)
Maintain / test cycles: 30 min/30 min (alternating hourly), extended 12 hour test
Charge retention test: Range: 12.2 - 12.7V. GOOD (green) = battery voltage > 12.7V
Size: 220 x 90 x 61 mm
Weight: 740g
Enclosure type: Fully sealed (IP54), 4 x wall mount tabs
Input cable length: 2m
Output cable length: 2m
Accessories included: O-1 fused eyelet set, weather protected; O-4 clamps set for bench charging
Operation temperature range: From –40ºC - 40ºC
Warranty: 2 years
AC supply: 100-240Vac 50-60Hz 1.5A@100V / 0.85A@240Vac
Reverse drain current: less than 0.1mA
Power usage (no battery connected): 0.0089kWh / day
Ratings / approvals (Safety, EMC, Energy efficiency, enclosure seal rating): IP54, CE, NRTL (UL & CSA), SAA (AU & NZ), PSE (Japan) approved by TUV Sud.



Add to Cart:

  • Model: TML10S
  • Shipping Weight: 1.001kg
  • 1 Units in Stock at PLUMSTEAD SHOP
    1 Units in Stock at BELLVILLE SHOP


This product was added to our catalogue on Friday 15 June, 2012.

Your IP Address is: 54.82.93.116
Copyright © 2018 Yebo Electronics. Powered by Zen Cart
Parse Time: 0.450 - Number of Queries: 198 - Query Time: 0.20796053987122